Cast resin branch sleeve
for plastic cables and wires as well as control and signal cables
Universally applicable for branching cables and wires with insulation
made of PVC, PE and XLPE (e g N(A)YY, TT ) Depending on the type, suitable for the installation of
single branch clamps (overhead line clamps for H1 and H2) or cable branch rings (H 5 and H2).
(H 5 and H 6) Suitable for compression or screw connectors
Application/suitability
- Indoor
- Outdoor
- Ground
- water
- Installation ducts
Voltage level
- U0/U (Um) 0.6/1 (1.2) kV
Test standards
- DIN EN 50393 (corresponds to VDE 0278)
Storage time/durability
- Casting resin up to 40 months
Characteristics
- Compact dimensions
- Splice position visible before potting
- High-quality, transparent, impact-resistant plastic molded shells
- Can be used as a double branch joint (H 1 and H 2)
- Large filling opening for easy potting
- Resistant to chemical influences
- Resistant to alkaline earths
- Stabilized against UV rays
- Longitudinally and transversely watertight
- High electrical insulation values
- High mechanical strength
- Immediately ready for use
- Quick and easy installation, saves time and money
Scope of delivery
Hydrolysis-resistant PUR cast resin EG, measured ready to mix in a practical two-chamber mixing bag, seals, transparent plastic moulded shell, cable centring devices (H 5-35 and H 7), steel clamps (H 5 and H 6), protective gloves, installation instructions.